Adapters Request Portal

Thanks for the confirmation, Amarin! We'll support patient results only.

Dear Paola,

I have asked the analyzer specialist. The analyzer performs QC on all samples and returns the same results as the sample results. It did not need to be recorded in the QC module.

Please cancel the requirement of QC result.

Regards,

Amarin

Hello Amarin,

In the ASTM manual provided, we don't see any identifier for QC results described. May you please confirm is the instrument sends any?

Thanks,

Paola

Hello Amarin,

Thanks for reaching out! Yes, we're on time to change the manual and support ASTM protocol. I'll share it with my team and provide feedback if needed.

Regards,

Paola

Dear Paola,

I think the GDT format is difficult to support and programmers develop drivers.

Can we change the protocol from GDT format to ASTM format?

Best regards,

Amarin

Hello Amarin,

After reviewing the document attached in the request, we need more information about the messages.

• Can we have more information about the GDT format?

• Can we have real traces where we can see the character at the beginning and the end of the line?

• Can we know which is the QC identifier?

This information should be available in the files sent by the instrument.

Please, keep in mind that without this information, we will not be able to develop the driver.

Thanks,

Paola

Hello Amarin,

I see that the instrument manual you attached describes a proprietary protocol. May you please provide instrument's real traces, please? Although there are some examples in the manual, it's better to check instrument real messages to confirm that the messages are as described in the document.

Thanks,

Paola